EXPORTER_METRICS_SERVER_ADDR |
Address (host:port) to which to bind for hosting the Prometheus metrics server |
:9000 |
Any valid host and port combination; host may be empty to bind on all available addresses |
EXPORTER_LOG_LEVEL |
Determines the amount of detail included in the log output |
warn |
fatal , error , warn , info , debug |
EXPORTER_ASAIRAHT10_ENABLED |
Enable the Asair AHT10/AHT20 temperature and relative humidity sensors |
false |
true , false |
EXPORTER_ASAIRAHT10_I2C_BUS |
Number of I2C bus on which to find the sensor |
1 |
Any valid I2C bus available to the device. On Raspberry Pi, I2C buses 0 and 1 are typically configured on the GPIO header |
EXPORTER_ASAIRAHT10_I2C_ADDR |
7-bit I2C address of the sensor |
0x38 (dec 56) |
A valid 7-bit I2C address. May be specified in decimal or in hexadecimal when prefixed with 0x |
EXPORTER_CUBICPM1003_ENABLED |
Enable the Cubic PM1003 particulate matter sensor for measuring air quality |
false |
true , false |
EXPORTER_CUBICPM1003_DEVICE_PATH |
Path or name of block device through which to communicate with the sensor's UART interface |
/dev/ttyAMA0 |
Any valid path to a block device where the sensor is connected. Depending on the Raspberry Pi model, there may be two or four UARTs configured on the GPIO header. |
EXPORTER_PLANTOWERPMS5003_ENABLED |
Enable the Plantower PMS5003 particulate matter sensor for measuring air quality |
false |
true , false |
EXPORTER_PLANTOWERPMS5003_DEVICE_PATH |
Path or name of block device through which to communicate with the sensor's UART interface |
/dev/ttyAMA0 |
Any valid path to a block device where the sensor is connected. Depending on the Raspberry Pi model, there may be two or four UARTs configured on the GPIO header. |
EXPORTER_SENSIRONSCD30_ENABLED |
Enable the Sensiron SCD30 gas sensor |
false |
true , false |
EXPORTER_SENSIRONSCD30_I2C_BUS |
Number of I2C bus on which to find the sensor |
1 |
Any valid I2C bus available to the device. On Raspberry Pi, I2C buses 0 and 1 are typically configured on the GPIO header |
EXPORTER_SENSIRONSCD30_I2C_ADDR |
7-bit I2C address of the sensor |
0x61 (dec 97) |
A valid 7-bit I2C address. May be specified in decimal or in hexadecimal when prefixed with 0x |
EXPORTER_SENSIRONSGP30_ENABLED |
Enable the Sensiron SGP30 gas sensor |
false |
true , false |
EXPORTER_SENSIRONSGP30_I2C_BUS |
Number of I2C bus on which to find the sensor |
1 |
Any valid I2C bus available to the device. On Raspberry Pi, I2C buses 0 and 1 are typically configured on the GPIO header |
EXPORTER_SENSIRONSGP30_I2C_ADDR |
7-bit I2C address of the sensor |
0x58 (dec 88) |
A valid 7-bit I2C address. May be specified in decimal or in hexadecimal when prefixed with 0x |